This report was written from live scanner audio using automated transcription. Details are unconfirmed and may contain errors.

ROCK COUNTY, WI — Multiple fire and emergency units responded to what was ultimately confirmed as a false alarm during a roughly 90-minute response period beginning at 10:41 a.m. on Friday, August 21, 2026, scanner traffic indicated. A three-story commercial structure was among the locations involved, and units from several agencies were heard coordinating across Rock County throughout the morning.

Initial Response to Commercial Structure

Dispatchers first broadcast a fire call at 10:41 a.m. Shortly after, at 10:57 a.m., a unit identified as Townline reported on scene, describing a three-story commercial building. According to scanner traffic, the unit reported nothing showing from three sides, no visible signs of fire, and what was described as “horrible alarms.” The unit noted it was “walking” the scene as part of its initial assessment.

At the same time, Janesville Fire was heard on the scanner receiving a structure alarm at an unspecified location. Dispatchers relayed that a false alarm had been confirmed and that a cancel was being requested for Janesville Fire units.

Additional Calls Reported Mid-Morning

Activity continued across the county in the following hour. At 11:24 a.m., Janesville Fire was dispatched to assist at Prairie View, described over the scanner as a nursing facility located on Commercial Drive. Scanner traffic indicated EMS was en route for a medical call at that location, and that staff was already with the patient.

At 11:25 a.m., Rock County scanner traffic referenced an ambulance and unit G41 being routed to Beloit Memorial, though specific details surrounding that transport were limited in the broadcast.

Lift Assist and Additional Units Dispatched

At 11:33 a.m., scanner traffic referenced units 3-16 and 3-13 being directed to an area described in relation to Portland, with dispatchers referencing what appeared to be a mobile assistant alarm for a lift assist. The transmission was partially unclear, but the call appeared to involve a separate request for assistance in that area of the county.

At 12:09 p.m., Rock County scanner traffic indicated that unit 113, identified as Rockfire, was en route to an unspecified location.

Scene Cleared, False Alarm Confirmed

At 11:57 a.m., scanner traffic broadcast a code indicating a fire alarm had been flushed, referenced over the radio as “10-10-4 flush, code of fire alarm.” By 12:12 p.m., a unit from the town confirmed the alarm as a false alarm and cleared units from the scene. Dispatchers relayed that public units could be marked available, effectively ending the response.

No injuries were reported in connection with the fire alarm response, and no further details regarding the commercial structure’s identity or address were broadcast over the scanner.

Stay informed on Rock County public safety with the free daily 608 Scanner briefing, or become a member for live scanner audio and full incident transcripts.