This report was written from live scanner audio using automated transcription. Details are unconfirmed and may contain errors.
ROCK COUNTY, WI — Rock County fire units responded to a fire alarm at a hotel location on the morning of July 3, 2026, with the alarm ultimately being reset and units clearing the scene within roughly 25 minutes of their arrival, according to scanner traffic.
Initial Response
Dispatchers first reported the alarm at approximately 10:18 a.m., with scanner traffic referencing what appeared to be a fire alarm activation. Rock County fire units were heard being dispatched to the scene, with scanner traffic indicating units were en route and beginning to arrive shortly after the initial call went out.
Employee Reports No Emergency
By 10:28 a.m., scanner traffic indicated an update had come in from a person identified as an employee at the location. According to dispatchers, that employee reported that everything appeared to be fine and that fire units were not needed, suggesting the alarm may not have corresponded to an active fire situation.
Exterior Investigation Conducted
Despite the initial reassurance, units continued their response and conducted an exterior investigation of the structure. At approximately 10:35 a.m., scanner traffic referenced a possible fire alarm at a hotel location, with no damage reported from three sides of the building. A unit identified in scanner traffic as 8-15 was heard entering an exterior investigation and was noted as standing by at the scene.
Alarm Reset, Units Clear
At approximately 10:40 a.m., dispatchers reported that the alarm had been reset and was confirmed operational. The unit identified as 15 was then heard clearing the scene. No injuries were reported in scanner traffic, and no damage was referenced by responding units during the course of the call.
Additional scanner traffic at 10:44 a.m. referenced unit activity consistent with units returning from the scene, though those transmissions were partially unclear.
Scene Status
Based on scanner traffic, the scene was cleared by approximately 10:40 a.m., roughly 22 minutes after units first arrived. No investigators were referenced in scanner traffic, and no cause for the alarm activation was identified in the transmissions monitored. The call appeared to be resolved as a non-emergency alarm activation based on available scanner information.
Stay informed on Rock County public safety with the free daily 608 Scanner briefing, or become a member for live scanner audio and full incident transcripts.

